SOBOTA, J., Zdeněk BOCHNÍČEK a Václav HOLÝ. Friction and wear properties of C-N/MeNx nanolayer composites. Thin Solid Films. Oxford, UK: Elsevier science, 2003, roč. 94, č. 12, s. 155-159. ISSN 0040-6090.
Další formáty:   BibTeX LaTeX RIS
Základní údaje
Originální název Friction and wear properties of C-N/MeNx nanolayer composites
Autoři SOBOTA, J. (203 Česká republika), Zdeněk BOCHNÍČEK (203 Česká republika) a Václav HOLÝ (203 Česká republika, garant).
Vydání Thin Solid Films, Oxford, UK, Elsevier science, 2003, 0040-6090.
Další údaje
Originální jazyk angličtina
Typ výsledku Článek v odborném periodiku
Obor 10302 Condensed matter physics
Stát vydavatele Velká Británie a Severní Irsko
Utajení není předmětem státního či obchodního tajemství
Impakt faktor Impact factor: 1.598
Kód RIV RIV/00216224:14310/03:00009376
Organizační jednotka Přírodovědecká fakulta
UT WoS 000183716900029
Klíčová slova anglicky thermal stability; friction; X-ray scattering; carbon; NbN;ZrN;TiN
Štítky Carbon, friction, NBN, thermal stability, TiN, X-ray scattering, ZrN
Změnil Změnil: doc. RNDr. Zdeněk Bochníček, Dr., učo 438. Změněno: 5. 1. 2004 17:06.
Anotace
Nanolayer composite coatings enable creation of stable structures with unique properties, and in particular, combination of properties conventionally considered excluding one another, such as high hardness and high toughness. Coatings, typically 1-4 mum thick, were deposited at a total pressure ranging from 0.9 to 3 Pa, at relatively low substrate temperatures not exceeding 200 degreesC. We deposited nanostructured multilayer coatings of the C-N/MeNx type, where Me could be Ti, Nb or Zr. Various substrates such as, highly polished tungsten carbide, steel and silicon were used. This study concentrated on the tribological properties of C-N/MeNx nanostructured multilayers. The friction coefficient, wear and the film transfer in a ball-on-disk tribometer were presented. The samples were measured after the deposition and then thermally treated at a constant temperature in the air. Afterwards, the samples were again measured and then exposed to a higher temperature, until the layer broke down. We also investigated the structure of the coating by means of low-angle X-ray reflection and high-angle X-ray diffraction. The potential application of C-N/MeNx nanolayer composites as hard solid lubricant is discussed.
Návaznosti
MSM 143100002, záměrNázev: Fyzikální vlastnosti nových materiálů a vrstevnatých struktur
Investor: Ministerstvo školství, mládeže a tělovýchovy ČR, Fyzikální vlastnosti nových materiálů a vrstevnatých struktur
VytisknoutZobrazeno: 27. 4. 2024 00:05