Další formáty:
BibTeX
LaTeX
RIS
@article{2264260, author = {Drevet, Richard Gaetan Paul and Souček, Pavel and Mareš, Pavel and Dubau, Martin and Czigány, Zsolt and Balázsi, Katalin and Vašina, Petr}, article_number = {April}, doi = {http://dx.doi.org/10.1016/j.vacuum.2023.111870}, keywords = {Reactive magnetron sputtering; Aluminum oxide; Tantalum oxide; Multilayer thin films; Dielectric strength; Dielectric breakdown}, language = {eng}, issn = {0042-207X}, journal = {Vacuum}, title = {Multilayer thin films of aluminum oxide and tantalum oxide deposited by pulsed direct current magnetron sputtering for dielectric applications}, url = {https://doi.org/10.1016/j.vacuum.2023.111870}, volume = {210}, year = {2023} }
TY - JOUR ID - 2264260 AU - Drevet, Richard Gaetan Paul - Souček, Pavel - Mareš, Pavel - Dubau, Martin - Czigány, Zsolt - Balázsi, Katalin - Vašina, Petr PY - 2023 TI - Multilayer thin films of aluminum oxide and tantalum oxide deposited by pulsed direct current magnetron sputtering for dielectric applications JF - Vacuum VL - 210 IS - April SP - 1-10 EP - 1-10 PB - Elsevier SN - 0042207X KW - Reactive magnetron sputtering KW - Aluminum oxide KW - Tantalum oxide KW - Multilayer thin films KW - Dielectric strength KW - Dielectric breakdown UR - https://doi.org/10.1016/j.vacuum.2023.111870 N2 - This research describes the synthesis of multilayer thin films of aluminum oxide and tantalum oxide for dielectric applications. The multilayer thin films are made of two, four, or eight oxide layers produced by physical vapor deposition (PVD), specifically mid-frequency pulsed direct current magnetron sputtering. The oxide layers are stoichiometric Al2O3 and Ta2O5 with two specific morphologies observed from cross-section images obtained by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The Al2O3 layers exhibit a columnar structure whereas the Ta2O5 layers are uniform and dense. However, the morphology of the Ta2O5 layers changes progressively in the four-layer and eight-layer systems under the influence of the morphology of the Al2O3 layer below. This behavior is induced by the morphological continuity of the interface between two oxide layers. X-ray diffraction (XRD) shows the low crystallinity of these oxide layers due to the experimental conditions used during the magnetron sputtering process, particularly the low deposition temperature. The dielectric behavior of the multilayer thin films is studied by dielectric strength measurements. The results are compared to the values obtained for single layers of Al2O3 and Ta2O5 produced under the same experimental conditions. The two-layer system shows an intermediate value compared to the single layers, higher than Al2O3 and lower than Ta2O5. The dielectric strengths of the four-layer and the eight-layer systems are higher than those measured for the single layers of Al2O3 and Ta2O5. Finally, the morphology and the crystallinity of the multilayer thin films are changed by thermal annealing of these samples at 850 °C under vacuum. The thermal annealing induces crystallization of the Ta2O5 layers and the loss of morphological continuity at the interface between the oxide layers. These modifications result however in a lower dielectric strength for all the multilayer thin films. ER -
DREVET, Richard Gaetan Paul, Pavel SOUČEK, Pavel MAREŠ, Martin DUBAU, Zsolt CZIGÁNY, Katalin BALÁZSI a Petr VAŠINA. Multilayer thin films of aluminum oxide and tantalum oxide deposited by pulsed direct current magnetron sputtering for dielectric applications. \textit{Vacuum}. Elsevier, 2023, roč.~210, April, s.~1-10. ISSN~0042-207X. Dostupné z: https://dx.doi.org/10.1016/j.vacuum.2023.111870.
|