2009
Substrate-Assited Laser Desorption Inductively-Coupled Plasma Mass Spectrometry for Elemental Detection in Microcolumn Effluent and Biological Submicroliter Samples
PREISLER, Jan; Pavla JUNGOVÁ; Ondřej PEŠ; Tomáš VACULOVIČ; Jarmila NAVRÁTILOVÁ et al.Základní údaje
Originální název
Substrate-Assited Laser Desorption Inductively-Coupled Plasma Mass Spectrometry for Elemental Detection in Microcolumn Effluent and Biological Submicroliter Samples
Název česky
Kombinace hmotnostní spektrometrie laserové desorpce s indukčně vázaným plazmatem pro elementální detekci mikrokolonových eluátů a biologických submikrolitrových vzorků
Autoři
Vydání
23rd International Symposium on MicroScale Bioseparations (MSB), 2009
Další údaje
Jazyk
angličtina
Typ výsledku
Konferenční abstrakt
Obor
10406 Analytical chemistry
Stát vydavatele
Spojené státy
Utajení
není předmětem státního či obchodního tajemství
Odkazy
Označené pro přenos do RIV
Ano
Kód RIV
RIV/00216224:14310/09:00029473
Organizační jednotka
Přírodovědecká fakulta
Klíčová slova anglicky
laser desorption; laser ablation; inductively coupled plasma; SALD; copper; submicroliter samples; myeloid leukemia cells
Příznaky
Mezinárodní význam, Recenzováno
Změněno: 9. 4. 2013 12:29, prof. Mgr. Jan Preisler, Ph.D.
V originále
A new method of sample preparation for elemental analysis using substrate-assisted laser desorption inductively-coupled plasma mass spectrometry (SALD ICP MS) is presented. Well-defined submicroliter volumes of analyzed samples are deposited onto polyethylene terephthalate glycol (PETG) plate and, after insertion into a commercial ablation cell, desorbed with pulses of 213-nm laser and analyzed with ICP MS. In contrast to conventional laser ablation (LA) ICP MS of solids, the analyzed compound is quantitatively desorbed during the PETG ablation. Furthermore, complete desorption is achieved at laser power density as low as ~10 MW/cm2, two orders below the levels typical in LA ICP MS. Model samples of metal salts in pg quantities were desorbed by less than 20 laser shots and relative spot-to-spot reproducibility was 3-10%. The limits of detection of Cr, Cu, Co, Fe, Ni, Sn and Zn deposited on the target were in the range of 50-500 fg. Selection of optimal conditions, such as laser fluence, number of laser shots, type of raster etc. will be discussed. The low limits of detection allow using SALD for off-line coupling of capillary electrophoresis (CE) to ICP MS.
Česky
Viz anglický popis.
Návaznosti
| GA203/09/1025, projekt VaV |
| ||
| MSM0021622411, záměr |
| ||
| MSM0021622412, záměr |
| ||
| MSM0021622415, záměr |
|